Hmm, make sure you don't have odd settings with volumes and master volumes. Try to keep every block close to unity gain and avoid digital clipping. Remember that amp blocks at an output level of 0 are usually extremely loud. Do you change the X/Y states of those amps aswell?Not really sure if this is a bug because I just started using the "Scene" functionality but when switching between 2 scenes that use a different amp, you get a "pop" (see attached image for example).
Other than that, FW10 rules!
I have them setup in parallel and I'm having the same issue.And have you tried putting the amps in parallel, both with "mute" bypass setting? Maybe it's due to the bypass filter not rolling off as fast as it should?
Hmm, make sure you don't have odd settings with volumes and master volumes. Try to keep every block close to unity gain and avoid digital clipping. Remember that amp blocks at an output level of 0 are usually extremely loud. Do you change the X/Y states of those amps aswell?
Which amp models do you use so we can try to recreate the issue?
Please list the amp models involved.
There seem to be a couple of amps that "Pop" when switching to that model.
Ahhh, the classic mistake. Don't put amp blocks in series. Especially when one is clean and the other is high-gain. Always put them in parallel and set the bypass mode to mute.