Conley Shepherd
Experienced
Just updated to fw v7 for the AF3.
I rebooted and everything came up as expected, patches change, scenes change, layouts changed as expected.
I then pressed my stand in switch that goes between layout 7 and the looper. When pressing the looper for a couple seconds the entire fc12 LCDs went blank. They were still lit, but no writing. I was able to navigate through the layouts, I am presuming since no writing could prove it, but zero writing in the LCDs.
I reboot and not able to repro the issue. This is the 3rd time this has happened to me.
Putting this out there in case anyone else runs into it.
I rebooted and everything came up as expected, patches change, scenes change, layouts changed as expected.
I then pressed my stand in switch that goes between layout 7 and the looper. When pressing the looper for a couple seconds the entire fc12 LCDs went blank. They were still lit, but no writing. I was able to navigate through the layouts, I am presuming since no writing could prove it, but zero writing in the LCDs.
I reboot and not able to repro the issue. This is the 3rd time this has happened to me.
Putting this out there in case anyone else runs into it.