lebihanj said:1 TRS from pedal out to the Midi Mate. This should allow the Midi Mate to convert the continuous analog signal from the pedal to MIDI and send MIDI to the Axe-FX. Then a mono (TS) cable from the switch out to one of the foot switch ports on the Axe-FX. Setup the port via the Axe-FX software for latching switch, and you should be good to go. I haven't tested with a Midi Mate so I am not sure what polarity it requires. If it is reversed from the Axe-FX, you will either want to order the SP-1R option with the polarity toggle switch, or I can provide you with instructions on how to hard rewire the pedal for reversed polarity.
Just bought one on ebay with the reverse polarity switch add on. I am guessing that when the Fractal MFC controller comes out that I will just run 2 cables from the CC pedal into the 1 & 2 exp pedal input slots on the floorboard and that will work. Is the pedal labeled so I know which cord goes where?