Dang it! Was hoping to do this on my own. I don't want to bork anything so I'm asking for help. My GCP is set up for virtual pedal board: bottom four buttons are patches, top eight buttons are IA's for chorus , trem , drive, etc. I have a TRS insert cable attached to the IN and OUT of the EB and into PEDAL 1 on the GCP. GCP manual says " Before using expression pedals, you need to enable them from the Pedal category of Setup mode" " After you select a preset and enter Edit mode, you can specify what each expression pedal will control by pressing Select ( w/ down arrow) untill you see the following display: PI. 064 CTL007." Well, what do they mean by " when you select a preset and enter edit mode" ? I have tried selecting patch 001, then holding down EDIT button and DEVICE 00 comes up. I then press the down arrow hoping to see the PI. 064 CTL007 but I get " INIT ", I press down arrow again and I get " SAVE TO 01 " By " select a preset" do they mean from the top two rows of buttons? I'm worried I'll disable one of my IA's now used for FX on/off. Do I have to have a free IA button that isn't assigned to the Axe to set up the EB Vol. ? I'm pretty confused and don't want to make a mess of things. I'd sure appreciate any help. Thanks so much!