Couple of issues since FW10 UG

Axe5288

Axe5288

Inspired
1.After FW 10 upgrade..... when I power up the FX, I have to change presets on the MFC to get the volume pedal to work.

2.When changing cabs using a stereo config....Changing Left cab, changes Left & Right to the same cab. When U change the right cab only the right cab changes. Even after "saving" the preset this still occures.


*Did Sys reset after UG. Didnt have these issues befor UG. I appreciate any help on this.


 
On power up, I have noticed that I couldn't engage some effects with the MFC switches until I changed presets.
 
1. IIRC this is a known bug and they are working on it

2. Switch stereo link off (cab menu page 2) if you don't want this behavior
 
I've seen the MFC thingy too, can't turn effects on/off unless I cycle to another preset first.
no biggie
 
The only issue I see is that horrendous font you're using for your posts. (Sorry... for whatever reason, this struck me as hilarious... forgive me)

But, seriously... this is your answer...

Hubertus said:
2. Switch stereo link off (cab menu page 2) if you don't want this behavior
Click to expand...
 
The Volume pedal not working, is a known bug that is being resolved in a future Firmware update... I had the same problem..
 
You must log in or register to reply here.
Back
Top Bottom