MockingbirdSupreme
Inspired
...ok, I've messed something up and cannot for the life of me figure out what I did.
I have two expression pedals and two foot switches connected to the 4 external 'pedal' jacks. I had one of the expression pedals in #4 controlling reverb/delay...and had one of the foot switches into #2 controlling a phaser. I wanted to get the two expression pedals by each other in the order (just easier to remember when hooking everything up), so I switched #4 and #2. Went into the control menu on each effect and re-assigned them....then went into I/O menu and 'told' the AX8 what I wanted the pedals to be (momentary/latch/continuous)....
Well...the expression pedal works ok...I have to engage it twice to turn the effect off and on, but that's ok. What's driving me nuts is it doesn't matter what I do, the foot switch is now momentary instead of latching, even when I tell the AX8 to make it latch through the setup menu. I mean, it's not the end of the world, because if I hold the foot switch down the phaser works fine...but the moment I take my foot off the effect is turned off regardless of what the I/O is set to.
Any suggestions? Thoughts?
I have two expression pedals and two foot switches connected to the 4 external 'pedal' jacks. I had one of the expression pedals in #4 controlling reverb/delay...and had one of the foot switches into #2 controlling a phaser. I wanted to get the two expression pedals by each other in the order (just easier to remember when hooking everything up), so I switched #4 and #2. Went into the control menu on each effect and re-assigned them....then went into I/O menu and 'told' the AX8 what I wanted the pedals to be (momentary/latch/continuous)....
Well...the expression pedal works ok...I have to engage it twice to turn the effect off and on, but that's ok. What's driving me nuts is it doesn't matter what I do, the foot switch is now momentary instead of latching, even when I tell the AX8 to make it latch through the setup menu. I mean, it's not the end of the world, because if I hold the foot switch down the phaser works fine...but the moment I take my foot off the effect is turned off regardless of what the I/O is set to.
Any suggestions? Thoughts?