Closed Cab Sim On/Off in different Output

[cellopet]

This could be a good option for people who use Output 1 for PA and other Output for Power Amp + Real cabinet.
During these years I've always put cabinet as last block and split my signal going to a different output ( as suggested in the Axe Fx 3 Manual), and it works very well BUT some blocks ( as plex delays and verbs) sounds pretty different before or after the cab block. So my question and my dream is the ability to disable Cab Sim only for certain output, so I can build my rig with cabinet in the right place just after amp.
Thanks
Marcello

 

[2112]

f you're running two outputs as you described, run the cab block input mode in stereo and you'll preserve the stereo image of your delays and verbs.

 

[cellopet]

f you're running two outputs as you described, run the cab block input mode in stereo and you'll preserve the stereo image of your delays and verbs.

yes, I do like this, and pan -100/+100.
But the plex sound a lot different before or after the cab