• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

AXE FXII with Lexicon MPX-R1

ERC

New Member
Hello people!
i bought an Lexicon MPX R1 controller, with the latest firmware (2.11) and i dont can use this controller to access the scenes of Axe Fx II...
some help?
i found some posts about this, but i dont understand how to make this work..
with my FCB1010 i can acess all 8 scenes with pedal 1 to 8 without no problems.. but in this lexicon, i dont can do that!!
 

unix-guy

Legend!
Does the MPX allow you to define CC data values along with CC#?

If not then you can't do it directly.

You can look into PC Mapping but that is limited.

A quick check of the manual would appear that it only allows sending 0/127.

0699250E-2B76-4DA4-84E0-0F76E3566543.jpeg
 

ERC

New Member
Thank you for repply, i do this, but is not funccional..
Does the MPX allow you to define CC data values along with CC#?
i think no..

in fx mode change scene 1 to 8, only. and all the switchers 1 to 9 have the same CC number: 49.
 

unix-guy

Legend!
Thank you for repply, i do this, but is not funccional..

i think no..

in fx mode change scene 1 to 8, only. and all the switchers 1 to 9 have the same CC number: 49.
The CC number isn’t important because you can make the Axe Fx use whatever CC you want for scenes.

The CC data value is how you select which scene, and the manual page I showed seems to indicate you cannot assign the value. Only 0/127 are sent (as generic off/on values).

0 is a value that will select scene 1.

127 is a value that will select scene 8.

That is why you're seeing that behavior.
 

ERC

New Member
The CC number isn’t important because you can make the Axe Fx use whatever CC you want for scenes.

The CC data value is how you select which scene, and the manual page I showed seems to indicate you cannot assign the value. Only 0/127 are sent (as generic off/on values).

0 is a value that will select scene 1.

127 is a value that will select scene 8.

That is why you're seeing that behavior.
Now i understand! thank you again!
 
Top Bottom