AXE FXII with Lexicon MPX-R1

ERC

New Member
Hello people!
i bought an Lexicon MPX R1 controller, with the latest firmware (2.11) and i dont can use this controller to access the scenes of Axe Fx II...
some help?
i found some posts about this, but i dont understand how to make this work..
with my FCB1010 i can acess all 8 scenes with pedal 1 to 8 without no problems.. but in this lexicon, i dont can do that!!
 
Does the MPX allow you to define CC data values along with CC#?

If not then you can't do it directly.

You can look into PC Mapping but that is limited.

A quick check of the manual would appear that it only allows sending 0/127.

0699250E-2B76-4DA4-84E0-0F76E3566543.jpeg
 
Thank you for repply, i do this, but is not funccional..
Does the MPX allow you to define CC data values along with CC#?
i think no..

in fx mode change scene 1 to 8, only. and all the switchers 1 to 9 have the same CC number: 49.
 
Thank you for repply, i do this, but is not funccional..

i think no..

in fx mode change scene 1 to 8, only. and all the switchers 1 to 9 have the same CC number: 49.
The CC number isn’t important because you can make the Axe Fx use whatever CC you want for scenes.

The CC data value is how you select which scene, and the manual page I showed seems to indicate you cannot assign the value. Only 0/127 are sent (as generic off/on values).

0 is a value that will select scene 1.

127 is a value that will select scene 8.

That is why you're seeing that behavior.
 
The CC number isn’t important because you can make the Axe Fx use whatever CC you want for scenes.

The CC data value is how you select which scene, and the manual page I showed seems to indicate you cannot assign the value. Only 0/127 are sent (as generic off/on values).

0 is a value that will select scene 1.

127 is a value that will select scene 8.

That is why you're seeing that behavior.
Now i understand! thank you again!
 
Back
Top Bottom