Axe FX3 and wireless systems

[Werpinater]

Try the TAE out of the rack, you could be getting a ground loop through the rack ears depending on how the TAE and wireless ground.

To isolate that variable keep the routing the same, but just move the TAE physically out of the rack.

 

[AtomicBlaze]

I had squealing with wireless using 4cm. I switched to humbuster cables and that helped a lot, I can still get it to squeal though on extreme amp settings. Also a noise gate helped as well.

 

[Dominic Gibson]

Simplify, repatch 1 by 1 until the problem reappears. Sounds like you've maybe needlessly to complicated setup? Shouldn't be needing the Ebtech.

BTW, now I think about it, the squaling only happened with my Engl Fireball.

Oh I need up getting the Eb-Tech due to issues I was having with humming and all sorts due to my foolishly buying a Fryette Power Station.

 

[Harm]

You checked the output setting of the wireless? (Rotary wheel on the back)

 

[Harm]

Did you try the onther input of the axe? I found the front better than the rear with my sennheiser.

 

[Dominic Gibson]

Did you try the onther input of the axe? I found the front better than the rear with my sennheiser.

Unfortunately I did, but no difference. I've just decided to take the TAE out of the equation.