How do I make all the outputs the same level?
I feel like I used to be able to do this. I haven't used my III in several months as I've been playing my AX8 but just hooked it back up to try out 12.09.
I have a patch that is literally just input 1 and then split out four ways to output 1, 2, 3 and 4. Outputs 1 and 2 are about 20 db hotter than outputs 3 and 4. This is seen in the front panel meters and the output block meters in Axe Edit.
The front panel output knobs are all in the same position (fully clockwise, maximum). I've disconnected all cables except the front instrument input, the power cable and the USB cable (in order to use Axe Edit)
I've tried adjusting things in the I/O -> Audio menu. +4/-10 on 1/2 doesn't seem to do anything. Setting the Boost/Pad on 3/4 to 18 dB gets it close but they're still lower than 1/2.
I have an early-ish Axe III (day 1 waitlist I think) and I'm running firmware 12.09.
Thanks in advance.
I feel like I used to be able to do this. I haven't used my III in several months as I've been playing my AX8 but just hooked it back up to try out 12.09.
I have a patch that is literally just input 1 and then split out four ways to output 1, 2, 3 and 4. Outputs 1 and 2 are about 20 db hotter than outputs 3 and 4. This is seen in the front panel meters and the output block meters in Axe Edit.
The front panel output knobs are all in the same position (fully clockwise, maximum). I've disconnected all cables except the front instrument input, the power cable and the USB cable (in order to use Axe Edit)
I've tried adjusting things in the I/O -> Audio menu. +4/-10 on 1/2 doesn't seem to do anything. Setting the Boost/Pad on 3/4 to 18 dB gets it close but they're still lower than 1/2.
I have an early-ish Axe III (day 1 waitlist I think) and I'm running firmware 12.09.
Thanks in advance.