Axe FX III into Mark V Return Help

H

Hypieran

Member
Was wondering if I'm doing something wrong. Trying 4cm using a preset for clean where it basically uses an Amp Model and the power amp of my Mark V. However when I play I can slightly hear the Mark V distortion in background. Wondering if someone can help ? I'm using the Axe FX III 4cm in the manual. Where it uses In 1 of Axe then out 3 and out 4.
 
I’m assuming Output 1 is going to front end/input of the amp?

But how are you using both Out 3 and Out 4?
 
RevDrucifer said:
I’m assuming Output 1 is going to front end/input of the amp?

But how are you using both Out 3 and Out 4?
Click to expand...
Out 3/4 should go to the amp input.

4CM is covered in the manual.

It's likely that the loop in the amp is bleeding through. In this case mute the output that is going to the amp's input.
 
FractalAudio said:
Out 3/4 should go to the amp input.

4CM is covered in the manual.

It's likely that the loop in the amp is bleeding through. In this case mute the output that is going to the amp's input.
Click to expand...

Pffft, manuals.

Whenever I tried it with either my III or FM9 I just ran Out 1 to the amp’s input, and used Out/In 3 for the effects loop, but it didn’t last long because I wasn’t using Humbusters and the ground loop was a bit much. Maybe I should have RTFM. :tearsofjoy:
 
You must log in or register to reply here.
Back
Top Bottom