It’s a soft reset of these 2 base models. Not all amps.Excuse my misunderstanding, but do we have to make soft reset to all amps or only to these two modified:
"Updated Plexi 100W and 1959SLP models. A soft reset of the Amp block is required to load the new default values."?
Never ending progress to perfection. Thank you for all your relentless work FAS and to one and only developer.
But the reset has to be done manually, after all, it's not automated and these modified amps have to be re-selected again. Is this re-selection needed for all other amps to take advantage of latest changes (phase inverter parameters) for instance?
yes, the SLP, specifically, now has that thing that i imagine Mr. Townshend had in mind when he goaded Mr. Marshall to build the original.
Update, sounds f***in awesome cranking the 1959 SLP Jumped + boost through SS PA + CabWas just itching to try out some power amp distortion
They're easily identifiable by the CF Compression parameter, if it's set to 0 by default it doesn't have a cathode follower
I would say yes and no, someone could always turn up the parameter to engage the simulator then you might be under the impression that it has a CF.
It’s because the plexi was broken in the previous firmware. This just makes it right again.
I get that perspective.
It’s generally going to be your plate driven amps off the top off my head
That's why I wrote "by default".
The hiwatt modeled by Fractal doesn't have a CF apparently
I guess a soft reset would show the intended value, then you could choose to save it or not.
