Bug? AX8 tuner doesn't work

Utility menu, page button until you find it
You get to utility by pressing lock, store and then sw 3
 
I have the same problem after updating to Q9.2
The tuner hangs on A note and only restart helps.
I did not notice any coincidence so far
 
Hubertus said:
Shouldn't matter:

13 SPECIFICATIONS
Input Voltage: 100–240 VAC, 47 – 63 Hz (universal input)
Click to expand...
The reason I asked is because, if there’s not enough signal going into the tuner, it will mostly hear the power line frequency which, in countries with 50 Hz power, will be an out-of-tune A. Here in the USA, power arrives at 60 Hz, and the tuner displays an out-of-tune B instead.
 
Rex said:
The reason I asked is because, if there’s not enough signal going into the tuner, it will mostly hear the power line frequency which, in countries with 50 Hz power, will be an out-of-tune A. Here in the USA, power arrives at 60 Hz, and the tuner displays an out-of-tune B instead.
Click to expand...
But 50 Hz is between G and G#, closer to G.
 
You must log in or register to reply here.
Back
Top Bottom