Hi, I am presently using the Morningstar MC6 II as my midi controller. I have a bank setup where each button is assigned a function (record, play, undo etc). I notice that when I tap record it seems to engage right when pressed however every time I try to record a tight loop there always seems to be a audio gap after I have pressed the play button. My looper config is set to not quantize.
Is it possible that the MC6 just sends the signal slightly late and therefore does not trigger to stop the recording process and play? I have gone through it it very methodically and am used to looper with my previous Axe Fx II and my AX8 which worked perfectly.
Thanks,
Derek
Is it possible that the MC6 just sends the signal slightly late and therefore does not trigger to stop the recording process and play? I have gone through it it very methodically and am used to looper with my previous Axe Fx II and my AX8 which worked perfectly.
Thanks,
Derek