Phil emptiness.be
Inspired
Does anyone feel the looper is limited (time, quality, ease of use) ?
I wish for longer loop times in Stereo Undo mode. My primary use for a looper is in an acoustic trio which requires a stereo setup, but I'm unable to loop the full chorus progression of many songs within the 15 second limit. I've been forced to stick with the TC Electronic Ditto x2 for giging use. It's not a deal breaker by any means, but it would be nice.
My setup is a little odd for acoustic gigs. I run a mono acoustic side with a compressor, EQ, etc. On the other side I have a crossover, compressor, and octave whammy down effects chain running for a faux bass guitar setup. I use Out 1, but require both left and right outputs because I EQ the two channels very differently and mix them separately.Are you sending more than one mic/pickup or instrument through the Axe-FX and keeping them balanced L/R throughout?
I'm wondering if you're using one input channel and just have stereo effects. If so, it might be possible to place the looper before any stereo effects and use mono mode.
I wish for longer loop times in Stereo Undo mode. My primary use for a looper is in an acoustic trio which requires a stereo setup, but I'm unable to loop the full chorus progression of many songs within the 15 second limit. I've been forced to stick with the TC Electronic Ditto x2 for giging use. It's not a deal breaker by any means, but it would be nice.
I would gladly give up preset/cab memory for more looper memory, and FX block memory. I mean...who needs over 700 presets stored on the hardware? We have a computer software librarian for massive storage capabilities. Or am I confusing the type memory inside the Axe FX II? Maybe the preset storage does not use the correct type of memory and or cannot be reallocated for other purposes?other than maybe a lack of memory
Should have clarified, I'm still using the old fashioned Pedal Train board with the Ditto x2 (non Axe rig).I'd be interested in where in the signal chain you put the Ditto x2. I have one as well, and am still trying to figure out best placement (I have been using it at the end of the chain, after OUT1).
We have a computer software librarian for massive storage capabilities.
Axe-Edit ....Axe Manage presetssoftware librarian