Amp Block Not Allowing "Hard Reset"? Q9b

[Warrior]

Pressing "Bypass" 2x's in the amp block is not performing a hard reset (resetting all perimeters).

Any suggestions?

Axe-Edit keeps timing out on me so can't use it.

 

[Hellbat]

Two small points here...

You have to click it two times quickly, like double clicking a mouse.

Make sure you are using the Bypass button and not the FX Bypass.

 

[Warrior]

Two small points here...

You have to click it two times quickly, like double clicking a mouse.

CHECK.

sure you are using the Bypass button and not the FX Bypass.

CHECK.....Still not resetting.

 

[mr_fender]

Button issue maybe? Is your Bypass button functioning? If you press it once, does it bypass to the clean guitar signal? My XL resets blocks normally so far with Q9b.

 

[FractalAudio]

Working here.

 

[Warrior]

Here's a video I just shot showing me attempting to reset the amp block.
Hopefully it shows me making a stupid mistake and you can point me in the right direction.

 

[h.c.e.]

Here's a video I just shot showing me attempting to reset the amp block.
Hopefully it shows me making a stupid mistake and you can point me in the right direction.

Don't go back to layout first. Double click Bypass while in the block edit screen.

 

[Warrior]

Don't go back to layout first. Double click Bypass while in the block edit screen.

I new it was something stupid on my part.

I haven't used the front panel much at all in years. Been using Axe-Edit but I'm experiencing communication time out issues so trying to use the front panel.

Thanks for pointing this out!

 

[Hellbat]

Also, you had the drive block selected in layout and not the amp block.

 

[Bakerman]

Also, you had the drive block selected in layout and not the amp block.

False

 

[Warrior]

Also, you had the drive block selected in layout and not the amp block.

No the amp block was selected (Black).