rockforlive
New Member
Hi
I hope this questions has not already been asked, otherwise sorry for doing it again
I would like to set up volume increase and decrease switches on the MFC working for both outputs. I have output 2 directly connected to my tube power amp (without cab sims) and 1 to the mixer (with cab sims). On the AXE Wiki page it is described as follows:
---
The Axe-Fx II offers a very convenient way to adjust preset levels on the fly (in other words: without editing): Volume Increment and Volume Decrement. These commands (CCs are in the I/O menu) enable you to adjust the preset level in small steps while playing. Adjustments are saved automatically! These commands adjust the preset output level (Layout menu). Note: Vol Inc and Vol Dec only affect the signal through Output 1, not Output 2 (Effects Send)!
To make this work assign these commands to switches. Note: when assigning Vol Inc and Vol Dec to switches on the MFC-101, use the "OFF" value for the IA switch CCs off-message. Otherwise, each tap of the IA switch is interpreted as two ticks.
---
Since I am not very good in doing "Midi-things", could someone explain this a little more in detail for me. Your help is realy appreciated.
Thanks.
Marco
I hope this questions has not already been asked, otherwise sorry for doing it again
I would like to set up volume increase and decrease switches on the MFC working for both outputs. I have output 2 directly connected to my tube power amp (without cab sims) and 1 to the mixer (with cab sims). On the AXE Wiki page it is described as follows:
---
The Axe-Fx II offers a very convenient way to adjust preset levels on the fly (in other words: without editing): Volume Increment and Volume Decrement. These commands (CCs are in the I/O menu) enable you to adjust the preset level in small steps while playing. Adjustments are saved automatically! These commands adjust the preset output level (Layout menu). Note: Vol Inc and Vol Dec only affect the signal through Output 1, not Output 2 (Effects Send)!
To make this work assign these commands to switches. Note: when assigning Vol Inc and Vol Dec to switches on the MFC-101, use the "OFF" value for the IA switch CCs off-message. Otherwise, each tap of the IA switch is interpreted as two ticks.
---
Since I am not very good in doing "Midi-things", could someone explain this a little more in detail for me. Your help is realy appreciated.
Thanks.
Marco