I want to use the Axe III through the EFX Loop of a new Mesa Boogie TC-100 head.
1. I'm getting normal guitar volume, etc., through the amp when when the EFX Loop is turned OFF
using the Mesa Boogie TC-100 foot controller FX button to turn the EFX loop on the TC-100 on and off.
2. When I turn on the EFX Loop with foot controller or from the back of the TC-100, there is NO guitar volume at all.
If I turn off the EFX Loop on the TC-100, , the guitar volume is normal.
3. I've doubled checked that the cables are correctly going out of the Send on the TC-100 EFX Loop to Input 3 L on the Axe III and out of Output 3 L on the Axe III, to the EFX return on the TC-100. Per the manual, I've set input of Channel 3 on the Axe III to Left ONLY.
4. If I pull the cables out of the Axe III, and plug them into a pedal flanger, the EFX Loop on the TC-100 foot controller works fine.
So the problem is a setting in the Axe III
I've read the instructions 10x. No idea why there is no guitar signal at all when I turn not the EFX Loop on the TC-100 with the Axe III in the loop for effects only.
I've isolated the problem to a setting on Axe III. The problem is NOT the TC-100, as I said, the EFX loop works fine with pedals.
Please advise ASAP!
Thank you!
David
1. I'm getting normal guitar volume, etc., through the amp when when the EFX Loop is turned OFF
using the Mesa Boogie TC-100 foot controller FX button to turn the EFX loop on the TC-100 on and off.
2. When I turn on the EFX Loop with foot controller or from the back of the TC-100, there is NO guitar volume at all.
If I turn off the EFX Loop on the TC-100, , the guitar volume is normal.
3. I've doubled checked that the cables are correctly going out of the Send on the TC-100 EFX Loop to Input 3 L on the Axe III and out of Output 3 L on the Axe III, to the EFX return on the TC-100. Per the manual, I've set input of Channel 3 on the Axe III to Left ONLY.
4. If I pull the cables out of the Axe III, and plug them into a pedal flanger, the EFX Loop on the TC-100 foot controller works fine.
So the problem is a setting in the Axe III
I've read the instructions 10x. No idea why there is no guitar signal at all when I turn not the EFX Loop on the TC-100 with the Axe III in the loop for effects only.
I've isolated the problem to a setting on Axe III. The problem is NOT the TC-100, as I said, the EFX loop works fine with pedals.
Please advise ASAP!
Thank you!
David