geetarplayer
Experienced
Hey guys. I have one outboard effects pedal - a Strymon BigSky. I'm setting it up in the FX Loop. I understand that I need to set the mix to 100% with the FX Loop block running in parallel - I'm getting good results from that.
My question is, how to manage the AX8 physical knob settings for Out 1 and Out 2 (FX-send)? There are a lot of variables in play, so I was thinking of eliminating one of those by deciding that these 2 knobs will always be in the same position. If out1 is at 12:00, so it Out 2, and if I adjust it to 11:30, also do that with Out 2. Any "wetness" levels can then be kept to the mix section of the FX Loop block.
Is that the accepted way to handle this?
Thanks.
My question is, how to manage the AX8 physical knob settings for Out 1 and Out 2 (FX-send)? There are a lot of variables in play, so I was thinking of eliminating one of those by deciding that these 2 knobs will always be in the same position. If out1 is at 12:00, so it Out 2, and if I adjust it to 11:30, also do that with Out 2. Any "wetness" levels can then be kept to the mix section of the FX Loop block.
Is that the accepted way to handle this?
Thanks.