Hi all...I am new to the Fractal world and I jumped right in to the Axe FX 3...and loving it!
I seem to be having issues setting the input gain on channel one, even if I set it to 0 in the Setup/In, out page...
it still shows spikes to the end of the red when I go to the layout page to find the input meter.
If any mods are reading this it seems to me the input gain staging should be found in the "Input" block which seems to only contain the gate parameters.
As well the input meters should be on the same page as the one where you adjust the input gain....
Still neither of those suggestions will address my issue.
There seems to be some reduction in gain from turning the knob from 100% down to 0% but not much...this can't be right somehow...is this a bug or just me?
Cheers,Ken
I seem to be having issues setting the input gain on channel one, even if I set it to 0 in the Setup/In, out page...
it still shows spikes to the end of the red when I go to the layout page to find the input meter.
If any mods are reading this it seems to me the input gain staging should be found in the "Input" block which seems to only contain the gate parameters.
As well the input meters should be on the same page as the one where you adjust the input gain....
Still neither of those suggestions will address my issue.
There seems to be some reduction in gain from turning the knob from 100% down to 0% but not much...this can't be right somehow...is this a bug or just me?
Cheers,Ken