Thank you I'm getting only this option 44100.0 hzIf the clock on Komplete 6 is set to Spdif then it is 48k. If not you will hear clicks or other disturbances.
Add an FX Loop block to your preset in AX8 edit. connect your input block directly to this block. Connect your cab block to this block as well. Pan the FX loop block hard left(DI) and right(Dry amp). Connect the FX send outputs on the back of your AX8 to two inputs on your komplete. These will be two mono tracks in your Logic pro X with respective inputs set. connect the main outs (XLR or 1/4inch) to two other inputs on your Komplete. This will be a single stereo track in Logic X. This way you have a DI track, a dry amp and cab track and a fully wet track with all the effects.
So basically input->FX Loop ->pan hard left ->Komplete 6 input 1 = DI Signal
input->amp->cab->FX Loop->pan hard right->Komplete 6 input 2 = Dry help amp signal
input->effects(if any)->amp->cab->effects(delay, reverb etc if any)->main out L & R-> Komplete 6 input 3 and 4
You can do a lot more using AX8-Edit. You'll figure it out as you start playing with it.
I like the look of that setup. I'm going to try this myself. Thanks.If the clock on Komplete 6 is set to Spdif then it is 48k. If not you will hear clicks or other disturbances.
Add an FX Loop block to your preset in AX8 edit. connect your input block directly to this block. Connect your cab block to this block as well. Pan the FX loop block hard left(DI) and right(Dry amp). Connect the FX send outputs on the back of your AX8 to two inputs on your komplete. These will be two mono tracks in your Logic pro X with respective inputs set. connect the main outs (XLR or 1/4inch) to two other inputs on your Komplete. This will be a single stereo track in Logic X. This way you have a DI track, a dry amp and cab track and a fully wet track with all the effects.
So basically input->FX Loop ->pan hard left ->Komplete 6 input 1 = DI Signal
input->amp->cab->FX Loop->pan hard right->Komplete 6 input 2 = Dry amp signal
input->effects(if any)->amp->cab->effects(delay, reverb etc if any)->main out L & R-> Komplete 6 input 3 and 4 = Wet Signal
You can do a lot more using AX8-Edit. You'll figure it out as you start playing with it.
Logic
go to 'File/project settings/audio'
is the sample rate for an audio track. Not exactly out in the open
It's not a global setting, so if your Mixcontrol sticks at 44khz, the setting will have changed in Logic.
Hi sir actually I haven't .i just went with input 1/2@sunil999 I just posted this same question as a new thread... Just purchased a Komplete Audio 6 and I'm getting the same result as you -- selecting External Clock in Audio MIDI Setup forces the sample rate to 44.1. I'm able to get signal through S/PDIF in Logic at 44.1 as well. Curious! Any more luck on your end figuring this out?