unix-guy
Master of RTFM
Posted this as a reply to a different thread, but nobody seems to be looking at it. I thought I would re-post as a separate, specific bug in hopes of getting more attention. I will basically just re-post what I did here:
http://forum.fractalaudio.com/axe-fx-ii-bugs/96608-possible-bug-fw-18-beta7.html#post1161866
If it is just the OD, obviously I can just reset it in my presets... but my worry is that other amp settings from the Y-state of the block are not correct, or that it affects the Y-state of other blocks besides the amp.
Thanks,
Kevin
http://forum.fractalaudio.com/axe-fx-ii-bugs/96608-possible-bug-fw-18-beta7.html#post1161866
Ok, I have done some further testing and this sure does seem very like the bug affecting Y-state that occurred some FW versions back (as I mentioned in a previous post).
Starting in FW17.03, I took one of my affected presets (#41, AC20) and exported it as AC20-a.
In this preset, amp1/Y is the Triptik Modern with OD set to 2.
I then swapped X and Y on amp2 via Axe Edit, and exported this as AC20-b.
NO other changes made.
Next, I updated to FW18.07b.
Call up the preset #41, change amp1 to Y (Triptik) and OD is set to 10.
Load exported preset AC20-a, change amp1 to Y (Triptik) and OD is set to 10.
Load exported preset AC20-b, amp1 (Triptik) is active and OD is 2 - just like it is supposed to be according to my settings in the preset on FW17.
I am attaching screenshots and preset files.
Hopefully someone can look more seriously at this now.
View attachment AC20-a.syx
View attachment AC20-b.syx
If it is just the OD, obviously I can just reset it in my presets... but my worry is that other amp settings from the Y-state of the block are not correct, or that it affects the Y-state of other blocks besides the amp.
Thanks,
Kevin