DougB415
Power User
My test results:Amp 2 and Cab 2:
I tried asking this a few Beta revs back and got no real replies. So I try again.
My understanding is that AMP 1's Impedance curve will conform to CAB 1's Dyna-Cab in slot 1, if Auto Dyna-Cab Imp. is turned on.
This all works as expected and changes are seen on FX3 front panel's AMP 1 Speaker page. (AXE Edit does not yet show all updates).
If AMP 2 is hooked up to the same CAB 1 also with Auto Dyna-Cab Imp turned on....I see/hear no changes in AMP 2 (AMP 1 still works).
If I connect AMP 2 to CAB 2 with the expectation that Auto behaviour will work same as AMP 1 and CAB 1....still nothing.
No visual changes on AMP 2 speaker page on FX3 front panel, and no sound difference.
If I have AMP 1 into CAB 2 also no effect.
My conclusion is that currently Auto Dyna-Cab Imp behaviour only works between AMP 1 and CAB 1.
AMP 2 and CAB 2 have all the available parameters but Auto Dyna-Cab Imp. is not implemented yet.
Has anyone else noticed/experimented with this?
Could we get a confirmation that this is a correct interpretation of the current implementation?
Thanks
Amp Block 1 SIC gets changed when Cab block 1 Cab Slot 1 goes to Dyna-Cab.
Amp Block 2 SIC gets changed when Cab block 2 Cab Slot 1 goes to Dyna-Cab.
Amp Block 2 SIC does NOT get changed when Cab block 1 Cab Slot 2 goes to Dyna-Cab.
When you say CAB 2 you need to specify if you are talking about the Cab block or one of the 4 Cab slots within the Cab block.