I’m aware that on the reset screen you can select FC6 or FC12.
If you are running the following setup:
AXEFX3 -> FC12 -> FC6 (non-mirrored)
..when you execute the reset for the FC6, i think it assumes all devices in the daisy chain are the same and the FC12 gets loaded with the FC6 defaults.
If possible, would be good to add “push footswitch to identify” to target the recipient of the reset in the daisy chain.
I realize this is a corner case, thus a wish and not a bug.
Btw.. the work put into the defaults for both devices is well done!! Very cool possibilities right out of the gate!
If you are running the following setup:
AXEFX3 -> FC12 -> FC6 (non-mirrored)
..when you execute the reset for the FC6, i think it assumes all devices in the daisy chain are the same and the FC12 gets loaded with the FC6 defaults.
If possible, would be good to add “push footswitch to identify” to target the recipient of the reset in the daisy chain.
I realize this is a corner case, thus a wish and not a bug.
Btw.. the work put into the defaults for both devices is well done!! Very cool possibilities right out of the gate!
Last edited: