Does anyone else have this problem?
If I use an old laptop and old Midi interface ( the MI 2) for this operation I can get Ripwerx to work fine.
But trying to use the Axe Fx II as my midi interface and Ripwerx will not recognize the FCB1010.
I attach the 2 midi cables ( in and out ) to the Axe Fx II , and into the FCB1010 then plug in the USB cable from the Axe into my PC ( Win 7, 64 bit).
then load Ripwerx in order to use the Axe Fx II as my midi interface. I have the Axe Fx II USB driver going.
But when I ask Ripwerx to test my Firmware it says " a message was received but it is not a sysex message" and then Ripwerx will not send sysex to the FCB1010.
Any ideas ??
If I use an old laptop and old Midi interface ( the MI 2) for this operation I can get Ripwerx to work fine.
But trying to use the Axe Fx II as my midi interface and Ripwerx will not recognize the FCB1010.
I attach the 2 midi cables ( in and out ) to the Axe Fx II , and into the FCB1010 then plug in the USB cable from the Axe into my PC ( Win 7, 64 bit).
then load Ripwerx in order to use the Axe Fx II as my midi interface. I have the Axe Fx II USB driver going.
But when I ask Ripwerx to test my Firmware it says " a message was received but it is not a sysex message" and then Ripwerx will not send sysex to the FCB1010.
Any ideas ??