plyall
Power User
Folks -
Attached is my attempt at a two amp/two speaker BIG clean sound. It has a hair of chorus (easily surpressed) and a slow leslie (also easily bypassed) for subtle texture.
This is a 4 output patch. Many of the patch's nuances can be tweaked by simply adjusting the output mixer.
The output mixer (all the way on the right of AxeEdit labeled OUT) controls things as follows:
1) Output 1 - controls the level and pan or amp #1 (an AC30TB) - slightly chimier than the other amp. A touch of chorus is also on this leg/input. Bypass the chorus to supress it.
2) Output 2 - Controls the level of REVERB in the patch. A low value is probably all you will need.
3) Output 3 - controls the level and pan or amp #1 (a Twin Reverb) - slightly warmer than the other amp. The enhancer follows the cab... this may also be bypassed.
4) Output 4 - controls the amount of Leslie in the patch. The leslie is set slow to add richness.
To record just the clean sound by itself (no effects), do as follows:
a) Bypass the chorus (no chorus)
b) Turn output mixer #2 all the way down (no reverb)
c) Turn output mixer #4 all the way down (no leslie)
d) Bypass the enhancer if it's not doing it for your clean sound
This patch was created using:
Guitar: PRS McCarty (using neck p/u simgle coil)
Amp: Axe-FX II of course
Output: 2 Tech 21 PE-60's (powered 12"'s)
Enjoy, and make a mess!
Pete
Attached is my attempt at a two amp/two speaker BIG clean sound. It has a hair of chorus (easily surpressed) and a slow leslie (also easily bypassed) for subtle texture.
This is a 4 output patch. Many of the patch's nuances can be tweaked by simply adjusting the output mixer.
The output mixer (all the way on the right of AxeEdit labeled OUT) controls things as follows:
1) Output 1 - controls the level and pan or amp #1 (an AC30TB) - slightly chimier than the other amp. A touch of chorus is also on this leg/input. Bypass the chorus to supress it.
2) Output 2 - Controls the level of REVERB in the patch. A low value is probably all you will need.
3) Output 3 - controls the level and pan or amp #1 (a Twin Reverb) - slightly warmer than the other amp. The enhancer follows the cab... this may also be bypassed.
4) Output 4 - controls the amount of Leslie in the patch. The leslie is set slow to add richness.
To record just the clean sound by itself (no effects), do as follows:
a) Bypass the chorus (no chorus)
b) Turn output mixer #2 all the way down (no reverb)
c) Turn output mixer #4 all the way down (no leslie)
d) Bypass the enhancer if it's not doing it for your clean sound
This patch was created using:
Guitar: PRS McCarty (using neck p/u simgle coil)
Amp: Axe-FX II of course
Output: 2 Tech 21 PE-60's (powered 12"'s)
Enjoy, and make a mess!
Pete