VP4 Dimensions

[golfnut]

I'm trying to find out if a VP4 will fit depth wise on a temple audio solo board. The depth of the board is 8.5 inches. The FM9 is a bit over 9 inches deep so I would thing the VP4 would be a bit smaller.

 

[MJS68]

10x6.25

 

[golfnut]

10x6.25

Crap. Deeper than the FM9. For the sake of an inch and a half I got to go to the duo board.

 

[Sixstring]

Crap. Deeper than the FM9. For the sake of an inch and a half I got to go to the duo board.

No it's only 6.31 deep! Manual

 

[Admin M@]

 

[Bertotti]

No it's only 6.31 deep! Manual

Doesn’t look like the 6.31 takes into account the connectors depths and or any cables plugged in of course.

 

[Sixstring]

Doesn’t look like the 6.31 takes into account the connectors depths and or any cables plugged in of course.

No it would not, just the physical unit itself. If you are trying to keep thing tight lowprophile connector will be needed!

 

[Admin M@]

I measured the protrusion of the jack with the greatest depth (SPDIF) and it's about 9mm.
Cables would be extra.
The provided power connector is straight, not 90°. That would be about 45mm if you bent it to the extent safely possible.

 

[golfnut]

No it's only 6.31 deep! Manual

Duh. I should have known that. I knew the shape. as for protruding cables, I use all right angle ends.

 

[Sixstring]

Duh. I should have known that. I knew the shape. as for protruding cables, I use all right angle ends.

Ha! Those walk on water posts are tough huh I'm just glad to see I'm not the only one who isn't perfect around here

 

[chrisjnyc]

Do we need to watch out for the vents on the side or bottom? Does it use a fan? Also, looking to take off the feet on the bottom to velcro it down.

 

[ethomas1013]

There are not any vents on the VP-4.