Volume Pedal How to HELP

serge20261

serge20261

Inspired
Me again I think I will be the Fractal Pain In the A@#e
Can Someone explain how to get my volume pedal happening its hooked up to the All Access
I cant get it to work I only got to to point where the midi in light on the axe lights when i move the pedal up or down
Remember my instructions is for dummies LOL
Thanx
 
You need to tell the Axe where the midi signal is coming from, and what to do with it. How you do this will depend on how you want to use the volume, and where you want to insert it in the chain. For example, if you change the volume as it comes out of the amp, then the reverb and delay will ring on when you kill the volume. If you change the Output volume then it will kill the reverb too.

There are two stages to setting this up:
1. Assigning the midi signal to an Axe-FX variable. This is done in the I/O section.
2. Editing the amp settings (or the output parameters): setting the "level" to be controlled by your chosen variable.

As for the detailed instructions: RTFM, read the wiki, and experiment
 
You must log in or register to reply here.
Back
Top Bottom