Chromatizm
Power User
FW 6.00, but I've experienced this in other FWs.
When switching scenes, sometimes there are volume jumps and additional sounds like the previous scene is active for some time after you've switched scene, and the target scene sound starts with a certain delay. Not all amps/preset display the issue. Attached preset is Tim Pierce's G.O.T. FM9 (not FM3) preset with amps replaced for Buttery, which has this issue when switching between scenes 1-2-3. For example, when switching from 3 to 2, it seems like the volume increased for a fraction of a second while not resetting the "boost" setting, which results in a short loud sound, then the volume and the setting for the boost switch of a target scene are applied and it goes back to normal.
If you will set the Input boost to "on" on the scene 2, this behavior will expand when switching from the scene 2 to 1 too.
I use Input Boost and Saturation switches is all my presets, but not all of them are subject to this. I feel like the original preset has a similar issue between scene 1 and 3, but less pronounced.
I assumed Spillover might affect this, but there is no difference between "All" and "Off" setting.
When switching scenes, sometimes there are volume jumps and additional sounds like the previous scene is active for some time after you've switched scene, and the target scene sound starts with a certain delay. Not all amps/preset display the issue. Attached preset is Tim Pierce's G.O.T. FM9 (not FM3) preset with amps replaced for Buttery, which has this issue when switching between scenes 1-2-3. For example, when switching from 3 to 2, it seems like the volume increased for a fraction of a second while not resetting the "boost" setting, which results in a short loud sound, then the volume and the setting for the boost switch of a target scene are applied and it goes back to normal.
If you will set the Input boost to "on" on the scene 2, this behavior will expand when switching from the scene 2 to 1 too.
I use Input Boost and Saturation switches is all my presets, but not all of them are subject to this. I feel like the original preset has a similar issue between scene 1 and 3, but less pronounced.
I assumed Spillover might affect this, but there is no difference between "All" and "Off" setting.