Fixed Virtual Capo keeps resetting the mix to 100%

[Colorado Axeman]

when manipulating a preset in Axe-Edit I have the mix on the pitch/virtual capo block set at 5%... while manipulating the preset in various ways such as clicking on the pitch block, it keeps resetting to 100%. Also when I load up the preset it defaults to 100% even though it was at 5% when I saved it. I think I've seen this happen with a few other blocks as well but I can't remember which ones right now.

 

[jlynnb1]

just curious, why would you run the mix on the VC so low? The whole point is to transpose the guitar, like, well, a capo...

 

[Colorado Axeman]

just curious, why would you run the mix on the VC so low? The whole point is to transpose the guitar, like, well, a capo...

I'm using the block to add a 5th order harmonic at a very slight amount (virtual capo fixed at 7 semitones).

 

[jlynnb1]

I'm using the block to add a 5th order harmonic at a very slight amount (virtual capo fixed at 7 semitones).

maybe use one of the other pitch types? perhaps the virtual capo reverts because of it's intended use?

 

[Colorado Axeman]

maybe use one of the other pitch types? perhaps the virtual capo reverts because of it's intended use?

The Virtual Capo uses far less CPU power than the alternative... using the other one puts my preset over the CPU limit. Anyway if the block has the control than it should be expected to work properly irregardless of how it was originally intended.

 

[BryantP]

Version 1.05 should resolve this issue: https://forum.fractalaudio.com/threads/fm3-firmware-release-version-1-05.163159/

 

[ValentinC]

Hi, i have the issue with the Dual Harmony settings, returning the Mix to 50% everytime. Already installed FW1.05