Using outputs 1,2 and 3 live...

[CliveBarnes]

Hi, I have some upcoming gigs with huge stages. I don't run in ears. I usually play through two flightcased G66 Red Sound FRFR's in the amp position behind me (output 1) then output 2 copied for front of house. I usually get a little bit of my guitar back from the house stage monitor too.
For these shows I was thinking of running my two LD Icoa coaxial monitors alongside the house monitor for these bigger shows..
Testing it out, the G66's out of output 2 are fine but I'm running cables out of output 3 to the LD's and all its giving me is a completely dry guitar signal. I've copied output 1 to output 3..
What am I missing..?
Is this even possible..?
Or am I introducing a world of issues..?

Thanks for your help

 

[chris]

I've copied output 1 to output 3..

you've copied INPUT 1 to output 3. i think there is no output copy to out 3, as it's intended as a dry out for reamping or other gear.

you'll need to place Out 3 blocks in all presets you use.

 

[CliveBarnes]

Right you are, I did copy input 1 to output 3.. thanks for your help Chris. Much appreciated

 

[Raggashaggas]

How would the preset look if you were going to run out 2 FOH and out 3 thru a standard cab as a stage monitor?

 

[Greg Ferguson]

How would the preset look if you were going to run out 2 FOH and out 3 thru a standard cab as a stage monitor?

it sounds like p. 27 in the manual is what you want, or is very close.