Using my Ax8 in the 4cm and scene 2 is louder question

[cragginshred]

I am using the my Ax8 for pre and post effects for my real amps and am not running anything for a boost in scene 2 and it has a boost in volume. Why?
Normally I would put a GEQ in there and just bump the volume but there is nothing in there nor any modifiers.
Why would I be getting a volume spike?

Thanks!

 

[Habuman]

Although no modifiers are attached, do you have any values for Scene 1 or 2 in the Controllers section? Or maybe a slider was adjusted in the Output section? Just trying to narrow it down.

 

[cragginshred]

@Habuman Controllers then 'Scene' section had scene 2 at 81.1%. -That was it!!! You rock brother thanks

 

[cragginshred]

@Habuman any idea why periodically I get this weird digital bleed over thing when changing scenes? Not the delay spilling over. A quick 'whoosh' very quick. Seems to be tied to the plate reverb if activated.

 

[Habuman]

Double check your Reverbs, Phaser, Flangers, etc. to ensure that the "Mute FX In" is not selected. Both X/Y if you have setup that way. Should be Mute FX Out. That might be the issue. Not sure. Does it happen with one preset or all?

 

[cragginshred]

@Habuman seems like it's on a few. It is mostly fixed but I noticed it on a few still. I need to ck the phaser an Flanger too, much thanks!!