Using momentary switch to increase reverb mix?

[NickSwampMKE]

Hey guys,

I'm trying to get a little creative here with my options on the fly and am hoping this is possible. I use IA switch 11 as a delay hold and was hoping there's a way to make it work for ramping up a parameter like reverb 2's mix while I hold it down and return to default when it is released.

Thanks in advance for any input!

Nick Burbey Guitar Instruction - Media
www.facebook.com/nickburbeyguitar

 

[Zwiebelchen]

Just use an external control for this and assign the IA switch to the external control. Set switch type in your MFC to momentary. Remember that a switch only has off (CC value 0) and on [CC value 127] states, so I also recommend setting the "damping" control to the maximum so that the mix value actually ramps up smoothly instead of going there instantly.

 

[NickSwampMKE]

Thanks for the reply.

I tried this straight away with no luck, though I didn't try the damping parameter, and I was rushing before students started showing up.

I'll try again..

Thanks again!

www.nickburbey.com
www.facebook.com/nickburbeyguitar