Two outputs with a very small latency between them? Is this possible?

[kostein]

I'm gonna have my Axe II in a few days which I'm gonna use in a live situation.

What I want to do is to have two separate outputs going into two different cabs with a little latency between them, something like 50-100ms. For example when I hit a string, the sound of what I just played comes out of the left cab immediately with the right cab being quiet, and then 100ms later the sound comes out of the right cab, lagging 100ms behind.

Is this possible with the Axe II and if it is, how is it done?

 

[Montaillou]

Yes, I believe this is possible with the Enhancer effect block (haven't used it myself).

AxeFXII WIKI - Enhancer

 

[Beefcake]

Ridiculously easy to do. Just delay one side 100ms, mix 100%
Read the manual and the wiki, you'll figure it out quick enough.

 

[Beefcake]

Yes, I believe this is possible with the Enhancer effect block (haven't used it myself).

AxeFXII WIKI - Enhancer

That would be it, except the enhancer doesn't go to 100ms? Or does it?

 

[Sebastian]

Yes, I believe this is possible with the Enhancer effect block (haven't used it myself).

AxeFXII WIKI - Enhancer

That's the way the enhancer used to work until it was redone. It still works this way on the Std. and Ultra models. But the delay max is 20 ms.

@ kostein: it can be done with a delay block

 

[stm113]

Dumb question here but when you say cab do you mean something like a full range cab or a 2x12 or 4x12 kind of set up? Just asking to see if you're gonna be running a traditional stereo guitar rig type set up or FRFR set up.

 

[gin]

just add a digital delay with 100% wet and 100ms delay. routing goes like this

signal 1 ---- out 1
signal 2 ---- delay ----- fx block