Switch Light when used with Control Switch

[Jack Napalm]

I have a patch with an block bypass that is controlled by a control switch. When I start the patch the LED's around the footswitch are ON and the effect is OFF. When I tap the switch the light goes OFF and the effect turns ON.

Any way to control the light state? If not, can we make this a wish?

 

[biskitboy]

There is a CS setting per scene that defines its state as either Last, On, or Off. I’m not exactly sure about your needs here. Although, there is an issue about it not working properly on preset first load.

Sounds like you might want to flip the on/off values on the modifier page where you assigned this as well. Then your lights will be correct.

 

[Jack Napalm]

I did try setting the state with no luck. Their were no modifiers set, just CS1 assigned to a FC switch.

 

[Jack Napalm]

Sounds like you might want to flip the on/off values on the modifier page where you assigned this as well. Then your lights will be correct.

This helped me figure it out. Thank you.

In the Modifier I changed the MIN to BYPASSED and MAX to ENGAGED. By default they were switched.