This seems like a no brainer sort of thing people would want to be able to do with the FCs, but I don't know how to do it/if it's possible.
I have a clean preset that has Drive1/ChA as the Blues OD and Drive1/ChB as a fuzz.
I want to be able to setup foot pedals on the FC12 to access each of these as follows
Footswitch 1: Drive1/ChA
Footswitch 2: Drive1/ChB
Assume Drive1 is off when the preset loads.
1. If I tap FS1 when Drive1 is off, I want it to turn Drive1/ChA on regardless of what channel Drive1 is on at the time
2. If I tap FS2 when Drive1 if off, I want it to turn Drive1/ChB on regardless of what channel Drive1 is on at the time
3. If Drive1/ChA is on, Drive1 should turn off when I tap FS1
4. If Drive1/ChB is on, Drive1 should turn off when I tap FS2
5. If Drive1/ChA is on, Drive1 should stay on and switch to ChB when I tap FS2
Describing it is a bit involved, but it would be very intuitive in function. The question is, is this possible with the FCs?
Austin
I have a clean preset that has Drive1/ChA as the Blues OD and Drive1/ChB as a fuzz.
I want to be able to setup foot pedals on the FC12 to access each of these as follows
Footswitch 1: Drive1/ChA
Footswitch 2: Drive1/ChB
Assume Drive1 is off when the preset loads.
1. If I tap FS1 when Drive1 is off, I want it to turn Drive1/ChA on regardless of what channel Drive1 is on at the time
2. If I tap FS2 when Drive1 if off, I want it to turn Drive1/ChB on regardless of what channel Drive1 is on at the time
3. If Drive1/ChA is on, Drive1 should turn off when I tap FS1
4. If Drive1/ChB is on, Drive1 should turn off when I tap FS2
5. If Drive1/ChA is on, Drive1 should stay on and switch to ChB when I tap FS2
Describing it is a bit involved, but it would be very intuitive in function. The question is, is this possible with the FCs?
Austin