Short question about scenes mode

[Hansen]

I have not used this a lot so far and to my understanding it is better for preset switching when you use the same amps/cabs in the scenes. I have a preset with two scenes, the only difference between the scenes is that one turns off the drive block and turns on the delay. I get a big "buff" when I change between these scenes. I thought that scenes would give a more fluent switching. Am I doing something wrong here?

 

[geetarplayer]

Can you upload the preset here? Did you by chance use the output bus to change the levels of the 2 scenes? That had been known to cause this.

 

[chris]

Am I doing something wrong here?

Probably. Upload the preset so we can see what’s going on. Otherwise we have to guess hundreds of possibilities and have you try them all out.

 

[Hansen]

The preset is uploaded here. Scene 1 is rhythm sound and scene 2 the same, but without drive and with delay. Same amp and cab block. so I am a bit surprised why the switch between the two scenes is not more fluent.

 

[Hansen]

Probably. Upload the preset so we can see what’s going on. Otherwise we have to guess hundreds of possibilities and have you try them all out.

The preset is uploaded.