Sharing Blocks w/Multiple Sources

Is there a way to share blocks from multiple input sources but keep the audio signals separated and routed to multiple outputs?

Thanks
 
Yes, but only using:
1. blocks which process stereo in to stereo out
2. blocks whose wet signals don't cross channels
3. Left vs. Right in those cases.

You'll need to hard pan the signal left and right before it hits the blocks in question. You'd then need to route the audio accordingly two different output blocks

Here's a simple test you can do. If you wanted the two outputs in dual mono instead of hard panned, you'd need to use their Pan controls instead of their balance controls.

Also, you could do this with one stereo. input block and one stereo output block, but I assumed you meant multiple blocks.

1637619590233.png
 
Last edited:
Back
Top Bottom