Setting up FX Loop with X-Load ?

[Heinzi]

Hey Guys,

I got a routing question. For a comparison of some Class D Poweramps I´d like to make the following setup (i know, that´s nonsense , i just need it for the comparison purpose: the Preamp of the Axe FX thorugh different Class D PAs with the same IR):

In1 - Amp Block - Out 3 - to Power amp - Speaker Out of Power Amp to X-Load - X Load DI out to AXE FX In 3 - Cab Block - Out 1 (so essentially the poweramp and XLoad is in an n FX Loop Out3 and In3)

But it doesn´t work - any ideas what i´m doing wrong?
Thanks for your help!

 

[yek]

Cables connected like they should?

OUT 3 knob turned up all the way?

Check Layout >> Meters to see where the signal stops.

 

[Heinzi]

Thanks for the help yek! Yeah I did that - Out 3 shows signal but In 3 is only flickering:

 

[bdrepko]

Try to connect a cable from out3 directly to in3 and make sure that works. If so, the problem is in the power amp or X-load.