scene troubles

[andersen]

hey there

Ive just set up my presets to scenes to avoid gaps when switching but its still there!!?? whats the deal here?
Ive setup the mfc to have scenes 1-5 and it works fine, but it have terrible gaps when switching.

 

[yek]

You need to provide more info. For ex. are you using amp X/Y switching, etc.

 

[michl_666]

... using amp X/Y switching ...

This was the problem on my side. Altered the presets --> without X/Y. Gaps are gone!

 

[andersen]

View attachment EVH 5150 III v.04.syxwell i quess not. this is the preset, it has two different amp models in it, but i also gaps when switching between scene1 and 2 which is the same amp

 

[yek]

You have placed your two AMP blocks in series. Change that into parallel.

http://forum.fractalaudio.com/axe-f...ween-two-scenes-different-amp.html#post831962

 

[andersen]

Thank you mr. gandalf! you truly are one heck of a wizard

 

[andersen]

Wait! now i get the DI signal through when the other amp is bypassed?? 3 scenes here, when i want to play scene 1, that uses dirty amp i get a clean DI signal on top of that though the other amp (clean) is bypassed???

View attachment 5150 Diretone.syx

 

[yek]

You need to set Bypass Mode in both Amp blocks to Mute.

 

[Fl7x]

Check the bypass state on both amp blocks

Edit: you beat me Yek

 

[andersen]

love this forum… thx!

 

[antony71p]

i also have gaps from scene to scene , can somebody help me and tell me whats the problem that cause this gaps , thank you

View attachment BOOTSAUCE 1 rpn.syx

 

[fractalz]

In Scene 5, your AMP1 block is switching to the 'Y' state. This could cause a drop out. You should leave this on 'X' for all scenes.

I've also had good luck with using dummy Vol/Pan or Filter blocks to do routing and always leaving the amps on.