Alexis
Inspired
I do have a problem with changing scenes with 9.00 beta.
I hav a Dual amp Setup. One with clean Sounds, the other with drive sounds. On Scene 1 I have the DriveAmp on scene 2 the same with compressor on. On Scene 3 I have a CleanAmp with compressor.
If i switch from 1 to 2 it's fine then from 2 to 3 also but if I go back now to 1 and then to 2 or directly to 2 BOTH Amps are activated.
So to clear things up, if i switch once to the clean sound and then to the compressed drive sound i have both amps activated!
I've tried to save it bypassed but if I do the switching again the bug is back!
I've checked the MIDI I/O and CTRL tab, checked the Midi board and switched out with a different one to get 100% sure that this is a bug of the axe fx 2 programming.
And no I haven't used Axe Edit
I hav a Dual amp Setup. One with clean Sounds, the other with drive sounds. On Scene 1 I have the DriveAmp on scene 2 the same with compressor on. On Scene 3 I have a CleanAmp with compressor.
If i switch from 1 to 2 it's fine then from 2 to 3 also but if I go back now to 1 and then to 2 or directly to 2 BOTH Amps are activated.
So to clear things up, if i switch once to the clean sound and then to the compressed drive sound i have both amps activated!
I've tried to save it bypassed but if I do the switching again the bug is back!
I've checked the MIDI I/O and CTRL tab, checked the Midi board and switched out with a different one to get 100% sure that this is a bug of the axe fx 2 programming.
And no I haven't used Axe Edit
