Hey everyone. I've always setup my patches mono, as I only ever had a mono monitor setup and found that doing a sum L+R on stereo patches introduced phasing issues.
I'm looking for the best way to edit patches to make them stereo. Ideally, I'd like to run a dual amp setup and have each panned hard to left and right sides. However, I also want effects in-line as well. For example, say I had a dual amp setup running into a stereo delay. Do I need to hard pan each output of the amp/cabinet before it gets to the delay, or do I just pan the delay? Or, can it all be done at the very output? I imagine there is no 'correct' way and several ways to do it, I guess I'm just looking for the most 'practical' way, if you will.
I'm amazed at how little I've explored this unit....having had it since last December, I literally know nothing about it!
Thanks for any help,
Mark
I'm looking for the best way to edit patches to make them stereo. Ideally, I'd like to run a dual amp setup and have each panned hard to left and right sides. However, I also want effects in-line as well. For example, say I had a dual amp setup running into a stereo delay. Do I need to hard pan each output of the amp/cabinet before it gets to the delay, or do I just pan the delay? Or, can it all be done at the very output? I imagine there is no 'correct' way and several ways to do it, I guess I'm just looking for the most 'practical' way, if you will.
I'm amazed at how little I've explored this unit....having had it since last December, I literally know nothing about it!
Thanks for any help,
Mark