mlancaster1
Member
Hello, I have recently switched to an Axe-Fx 3 after using a Kemper for the last 6+ years. I've traditionally ran my Kemper through a VHT 2:90 to power my 4x12 on stage and send the direct signal to FOH. When looking through the manual, I am trying to run my Axe Fx 3 as shown on page 27 only instead of a solid state power amp, I am using a tube power amp. Can I use output 3 or 4 to go to the power amp since I only have the option to use 1/4 inch cables or do I have to use output 2 which would require an XLR to TRS cable? Also if I disable power amp modeling, does this affect the direct tone at all? I just want the ability to have good stage sound or best of both worlds but not sure if I need to make some tweaks compared to how I use to run my Kemper.
So far I am just getting use to the axe fx in general and trying to understand it as I have it plugged into my audio interface and studio monitors at the moment. I am thinking I need to either run this through a power amp and cab and mic it for live use, or ditch that idea and go direct which I'm not too big of a fan of. Any help would be appreciated, thanks!
So far I am just getting use to the axe fx in general and trying to understand it as I have it plugged into my audio interface and studio monitors at the moment. I am thinking I need to either run this through a power amp and cab and mic it for live use, or ditch that idea and go direct which I'm not too big of a fan of. Any help would be appreciated, thanks!