Liam Thompson
Inspired
I have just noticed the low cut slope in the reverb block is no longer working as of firmware 21.04.
Changing from -6dB to -12dB has no effect on the tone or the frequency graph inside the block.
This is within Axe Edit and also the front panel.
Behaviour is the same when starting with a blank preset and just adding an input, amp, cab, reverb and output block, or just the reverb block all by itself.
Changing from -6dB to -12dB has no effect on the tone or the frequency graph inside the block.
This is within Axe Edit and also the front panel.
Behaviour is the same when starting with a blank preset and just adding an input, amp, cab, reverb and output block, or just the reverb block all by itself.