Pressing 2 foot switches at the same time

[mischi_90]

Hey everyone

When I am pressing 2 foot switches at the same time it looks like one doesn't work properly. See in the video below. I guess its just something within my settings but I can't figure it out.


My goal:
Volume block is always on... When I want to engage the wahwah block I press 2 foot switches at the same time. Thereby the volume block should go off and the wahwah should go on. But it looks like my volume switch doesn't always work properly when hitting both switches at the same time. Pressed separately the switches work just fine.

I use to do this with my FM3 and there it works. What am I doing wrong?

 

[mischi_90]

I think this video will make problem more clear



When I am holding the volume switch down I can engage other switches. But when I am holding the WahWah switch down I can't engage other switches.

 

[mr_fender]

You can use a Control Switch instead. Assign the control switch to the bypass modifier of both the Vol/Pan and Wah blocks and in one of the modifiers swap the START and END values. That will toggle them opposite each other with just one switch.

 

[mr_fender]

Also, the hold function works differently on the bottom right switch (#6) because of the MLM Combo feature. That is likely what is messing with it. If you don't use the Master Layout Menu, you can turn off that MLM Combo feature.

 

[mischi_90]

Problem solved. Thank you very much!!! This is a very good trick with that Control Switch, never used this before but this makes totally sense.