prometh
Power User
Using "preset mapping mode" in I/O->MIDI, I currently have:
While this works, it could be better.
Basically, I think it'd be awesome if we could specify what scene is loaded per switch. Perhaps on an MFC page after the Preset Transit Map ("Axe-Fx TxMap 000->000"). Something like a Scene Transit Map where the value can be 1-8 (denoting a scene number) or 0 (denoting indefinite, which would be the current behavior).
- preset1 mapped to preset1+scene1
- preset2 mapped to preset1+scene2
While this works, it could be better.
- Pressing switch1 loads the correct preset+scene and lights up.
- Pressing switch2 loads the correct preset+scene, but does not light up and switch1 is lit.
Basically, I think it'd be awesome if we could specify what scene is loaded per switch. Perhaps on an MFC page after the Preset Transit Map ("Axe-Fx TxMap 000->000"). Something like a Scene Transit Map where the value can be 1-8 (denoting a scene number) or 0 (denoting indefinite, which would be the current behavior).
Last edited: