Wish Preference to keep delay feedback and reverb length the same when switching types

[Orvillain]

I'd find this useful. An option to keep the delay feedback and reverb length the same when switching between types.

 

[unix-guy]

I'm not sure how feasible that would even be for the Delay block as different models are not all consistent on the Feedback settings available.

Keep in mind the Delay has "types" and "models".

What are you trying to accomplish?

Is this a performance related request or for when you're auditioning types?

 

[Orvillain]

I'm not sure how feasible that would even be for the Delay block as different models are not all consistent on the Feedback settings available.

That's exactly why I want it. I want to set a baseline number of taps and then compare and contrast against all of the other models, and tweak up and down as I go, without having to start off at 10% each time.

It's a sound design workflow enhancement.

 

[mr_fender]

Makes sense for delays, but reverbs might lead to some weird results. A small room reverb with a 10 second decay is likely going to sound odd. For sound design though, that might be the point.

 

[kptkarl]

Save each type to your Library how you see fit. Not terribly time consuming.

 

[Orvillain]

Not terribly time consuming.

Nor would ignoring a preference you don't intend to use.

 

[unix-guy]

That's exactly why I want it. I want to set a baseline number of taps and then compare and contrast against all of the other models, and tweak up and down as I go, without having to start off at 10% each time.

It's a sound design workflow enhancement.

That use case makes sense.