Bug? Preamp Hardness & Pwr Amp Hardness not stored

[LPaulasBestFriend]

AxeFx II MKII
Firmware Q 2.01 beta 2 (newest)
TestAmp DR Z MZ-8

I just tested, if all parameters will be stored correctly.

Result:
All parameters will be stored correctly, except of

- if I change the Preamp Tube from 12AX7A to EF86 and Preamp Hardness to 0,
the Preamp Hardness has a value of 7.40 after storing the preset, calling another and
recalling the same preset.

- same with Pwr Amp Hardness; if I change the Power Tube from 6AQ5 to KT88 and
Pwr Amp Hardness to 0, the Pwr Amp Hardness has a value of 5.60 after doing the
procedure described above.

Kind regards!
Mike

 

[greiswig]

Partial confirmation here. I set up a new patch with just the Maz38 block. Preamp tube to EF86, preamp hardness to 8.86. Power tube set to KT-88, power amp hardness set to 8.88. Easy to remember values that way.

Change to a different preset, power down, power up, return to this preset. Hardness for power amp was saved, as was the power tube type. Hardness for preamp was now 7.40.

Same hardware and firmware as the OP.