Pre 10.02 Firmware "decimal" ID 125, what does this mean?? GT-10

W

WannaRock

Member
Hello, I am trying to get my axe to communicate through my gt-10. The Midi light adn 120 BPM lights are both flashing in axe edit. The Midi in light is flashing on the Axe. Midi input is labeled boss gt-10 in axe edit, midi output is labeled boss gt-10 in axe edit Midi channel = 1, Axe Fx sysex Id 00 00 7d and Pre 10.02 Firmware decimal Id 125

sysex Id = 125 on axe
midi buffer size = 128
midi buffer delay = 64ms
checked enable midi log

Loopback test failed
Stattus not connected check midi i/o in axe edit.

I HATE MIDI AND MIDI HATES ME!!!!

Anyone got any suggestions? I want to go from 10.01 firmware to 11
 
axe edit information

I went to axe edit quickstart. It explained alittle about the ID 125, as far as I can tell it is set correct?
 
I ran into the same kind of trouble when using Axe Edit and my Ultra; The setting - leading up to ID 125 - worked with an earlier firmware version, but not with 11.00. For that version I had to return to the original setting in the new Axe Edit, which is like this: 000174 = ID 372. That setting did not work on the earlier version of the firmware. It's things like these which take away the creativity... :-/
 
You must log in or register to reply here.
Back
Top Bottom